CathStack
Concept to CAD

Six steps. One shaft.

01

Targets

OD ceiling, lumens.

02

Layers

With tolerances.

03

Stack-up

Spread and Cpk.

04

Segments

Along the shaft.

05

Onshape

Parametric part.

The stack-up cross-section next to the generated Onshape model

Same numbers, two worlds.

Examples

Any construction.

Cut-back sheath: jacket, braid, pull-wire lumen, liner
Cut-back sheath
1-over-1 round-wire braid
1-over-1 braid
2-over-2 braid
2-over-2 braid
Flat-wire braid
Flat wire
Coil-reinforced shaft
Coil

64 reference constructions, tested

Segments

Changes along the shaft.

Jacket durometer change

A stiffer proximal jacket meets a softer distal one, while the liner and braid run through.

Reinforcement change

The braid ends and a coil or plain jacket takes over toward the tip.

Step in OD or lumen

The wall or a lumen steps down where the shaft narrows toward the distal end.

Figures

From the analysis.

Sample report

What a design review gets.

Page 1Page 2Page 3

Proximal shaft

19 pages · PDF · 151 KB

Open the sample report

See it on your shaft.

A live walkthrough on your own construction.